Lawnmowers can be very expensive to buy and maintain, but fortunately, there is a way to save money. We have the best tips for charging a lawnmower battery to help you get more use out of your batteries and keep you on the go.
You know that the longer you leave your lawnmower into colder months, the more likely it is to run out of battery. However, there’s no need to panic if your lawnmower needs a little extra power and it’s not unusual for most batteries to lose 30% of their charge over a couple of days, but that doesn’t mean you need to rush out and buy a new battery. Here are a few tips for extending the life of your battery.
How long does it take to charge a lawnmower battery?
Charging times for electric lawnmowers depend upon battery type and charger type. There is a wide range of electric lawnmowers with fast charging. They can be fully charged and ready to use in around 100 minutes and will run for 1 and 2 hours and up. other side large lawnmowers can be charged in 3 to 4 hours with the fast charging system and 1. a 5-hour operating time. Weibang iON 81 RC is also a big lawnmower its charging time is 12 hours and will run 3 and 3.
|1.5 – 2 hours
|Smaller sit on mower
|Self-Propelled Commercial Mower
|Big sit on mower
|Big sit on mower
How Does the Lawnmower Battery Work?
It’s important to understand the mower battery before you start the process to recharge it. I. In simple terms, the battery stores its charge in the form of chemical energy, and when the battery discharges, it is converted to mechanical energy via the alternator to be used to run. There are times when the battery needs to be recharged after it is used.
The Charger You Use Matters:
Factors to consider in a charger
- Voltage of battery
Voltage of battery
The two terminals on a battery are its positive and negative terminals, and the difference between the potential of the two terminals is the voltage. Almost every modern battery-powered lawnmower runs on 12V batteries. This voltage is recommended for lawnmowers because it can power the machine without causing shocks to the operator. It can also last a few hours of use. In the 1980s most lawn mowers were 6-volt batteries.
Amperage is another major factor in the charging time of your lawn mower battery. Amperage is the strength of the electric currents that are measured in amperes, which are also called “amps. ” When charging a lawnmower battery, the charging rate is determined by amps. You will need a maximum of ten amp chargers for your lawn mower chargers. Any higher, and could cause damage to the battery.
A charger has a set of frequencies that you can use to match your battery to a suitable charger.
Pro Tip: Always keep the frequency of your charger in mind before you plug it in.
A few modern chargers come with additional features such as additional features that extend their battery life or improve charging safety
Now Most lawn mower chargers have jumpstart settings(Jump-starts are a great way to give old batteries a new lease on life, ) that can bring dead batteries back to life.
Other battery charging features include:
- Multiple mode settings,
- like fast charge,
- slow charge,
- and float mode
- Hookup failsafe
- Built-in charging timer
- Changeable amp rates
Multiple mode settings, fast charge, slow charge, and float mode
It’s a great feature that can extend battery life, but you need to understand how it works. The mode setting determines how the charger should charge the battery. There are three modes: float, fast, and slow. The float mode is the standard charging mode, where the charger uses a trickle charging rate to slowly bring the battery up to the correct voltage. The fast mode uses a fast charging rate, and the slow mode uses a slow charging rate. When using the slow mode, the charger will not stop charging until the battery reaches the specified voltage.
The hookup failsafe is an important feature that protects the battery from being damaged if it gets disconnected. It also protects the charger from damage if it gets disconnected. This is a safety feature, and you should never use a charger without a hookup failsafe.
Built-in charging timer
The built-in charging timer is an added another useful safety feature that prevents the charger from overcharging. The timer can also be used to automatically shut off the charger when the battery reaches the correct voltage.
Changeable amp rates
This feature lets you adjust the amps rate to suit your lawn mower. Where your charger has a low rate, you can increase the rate to suit your battery. This will increase the charging time. Where your charger has a high rate, you can reduce the rate to suit your battery. This will reduce the charging time.
How Can You Charge a Lawn Mower Battery Properly?
we share with you some useful tips to charge your lawnmower battery
1. Follow Basic Safety Guidelines
Always follow basic safety guidelines when charging a lawnmower battery. You need to wear safety goggles and thick work gloves to protect you from electric shock. Check your mower’s electrical system for any symptoms of damage, like frayed connections, bloated battery, and other problems.
2. Choose the Right Charger
Always use the proper charger for your battery. Use only a charger that matches your battery type and the amp rate of your battery. Then Set the Frequency It is important to know the frequency of your charger before you plug it in. You will need to match your charger to the battery.
3. Locate the Battery
Locate the battery in the mower. If you don’t know where the battery is, look under the seat because Most mowers have their battery underneath the seat. Lift the seat and look for a positive and negative battery terminal. You can also use a multimeter to check the voltage of the battery.
But not all mower has the same design and if you face trouble locating the battery don’t worry most manufacturers have online resources you can use to find answers.
4. Connect the charge
After locating the battery connect the charger cord to the battery. You will need to match the positive and negative terminal. If you are using a charger with a plug-in, make sure you are plugging the red cable to the positive terminal of the battery and the black cable to the negative terminal and take care of the that Always start with the positive terminal.
5. Rest the Battery Before Disconnecting
This is a common problem for many batteries, especially Ni-Cd batteries and lead-acid batteries. Using these gases can harm your mower and your health if you don’t wait until they disperse. You should wait at least five minutes before detaching your charger cables.
Mostly Gas issues usually occur in lead-acid batteries and Ni-Cd batteries. If you have a lithium-ion battery, you can skip this step.
6. Switch Off the Charger When the Charging Is Complete
If the charger warns you when the work is done, it should take about four to six hours to fully recharge your mower. The best thing about the smart chargers is that they automatically shut off the flow of charge once the battery attached is fully charged.
The most important thing to remember when charging a battery is to charge it at the correct rate. Charging a battery at a constant rate means that you can be sure that the battery is getting the right amount of current. But, you need to make sure that you don’t overcharge the battery. Overcharging a battery will damage it and reduce its life of the battery. This is because the voltage is too high and the battery has to work harder to supply the same amount of current.
Frequently Asked Questions
Answer: If the battery won’t start, make sure that you have the proper voltage and that the terminals are tight.
Answer: it depends on the size of the battery. The larger the battery, the longer it takes to charge. It usually takes one hour for a small battery.
Answer: The first step is to remove the spark plug.
Next, you need to disconnect the negative cable from the battery.
Then, you should connect the positive cable from the battery to the battery.